Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Release the clips.
Disconnect the electrical connector and remove the center registers.
Use the General Equipment: Interior Trim Remover
Instal..
B0004:11, B0004:12, B0004:13, B0004:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver knee airbag circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver knee airbag
If a fault is de..