Ford Ecosport: Rear Disc Brake / Removal and Installation - Brake Caliper
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Disconnect the rear brake flexible hose from caliper.
Torque:
159 lb.in (18 Nm)
-
-
Rotate the brake caliper lever.
-
Detach the parking brake cable from the brake caliper lever.
-
Detach the parking brake cable from the brake caliper bracket.
-
Remove the caps.
-
Remove the brake caliper guide pin bolts and the brake caliper.
Torque:
15 lb.ft (21 Nm)
Installation
NOTICE:
Make sure the brake hose is not twisted when installing the
brake caliper or damage to the brake flexible hose may occur.
-
To install, reverse the removal procedure.
-
Bleed the brake system.
Refer to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures).
Removal
NOTE:
Steps in the removal procedure may contain installation details.
Remove the brake pads.
Refer to: Brake Pads (206-04 Rear Disc Brake, Removal and Installation)...
Other information:
Special Tool(s) /
General Equipment
Hose Clamp Remover/Installer
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Drain the cooling system.
Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding
(303-03C Engine Cooling - 2...
System Operation
System Diagram
Item
Description
1
LH Horn
2
RH Horn
3
Horn Relay
4
BCM
5
Clockspring
6
Horn Switch
Horn Operation
The
horn switch consists of 2 sets of contacts separated by springs...