Ford Ecosport: Brake System - General Information / Specifications
Lubricants, Fluids, Sealers and Adhesives
| Item | Specifications |
|---|---|
| Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 | WSS-M6C65-A2 |
Torque Specifications
| Item | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front caliper bleeder screw | 8 | - | 71 |
| Rear caliper bleeder screw | 12 | - | 106 |
| Master cylinder brake tube fittings | 25 | 18 | - |
General Specifications
| Item | Specification |
|---|---|
| Front brake disc minimum thickness | 0.906 in ( 23 mm) |
| Rear brake disc minimum thickness | 0.354 in ( 9 mm) |
| Brake pad minimum thickness | 0.118 in ( 3 mm) |
| Brake pad maximum taper wear (in any direction) | 0.118 in ( 3 mm) |
| Maximum brake disc thickness variation | 0.001 in ( .018 mm) |
| Maximum brake disc runout (installed) | 0.002 in ( .05 mm) |
Diagnosis and Testing - Brake System
Symptom Chart(s)
Symptom Chart: Brake System
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Piston Selection
Check NOTE: Refer to the appropriate Section 303-01 for the specifications. NOTE: The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston. Measure the cylinder bore in 2 directions...
Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Perimeter Anti-Theft Alarm - System Operation and Component Description
System Operation System Diagram Item Description 1 RKE Antenna 2 Passive Key 3 With Push-Button Start 4 RKE Commands 5 BCM 6 IKT Key 7 Without Push-Button Start 8 RKE Commands 9 Passive Entry Commands 10 ..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- General Procedures - Transmission Fluid Drain and Refill
- Removal and Installation - Body Control Module (BCM)
- General Procedures - Battery Charging
- Description and Operation - Evaporative Emissions - System Operation and Component Description
- Removal and Installation - Transmission
Removal and Installation - Front Brake Flexible Hose
Removal
Remove the wheel and tire.Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Remove the brake flexible hose bracket bolt.
Disconnect the brake tube fitting and remove the brake hose clip.
Loosen the brake hose fitting and remove the brake flexible hose.
Copyright © 2026 www.foecosport2.com