Ford Ecosport: Front Disc Brake / Removal and Installation - Front Brake Flexible Hose
Removal
-
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
-
Remove the brake flexible hose bracket bolt.
-
Disconnect the brake tube fitting and remove the brake hose clip.
-
Loosen the brake hose fitting and remove the brake flexible hose.
Installation
-
NOTICE:
Make sure that the brake hose is not twisted and
correctly aligned when tightening the brake flexible hose fitting or
damage to the brake flexible hose may occur.
-
Install the brake flexible hose bracket bolt.
Torque:
18 lb.ft (25 Nm)
-
Position the brake hose, install the clip and connect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
-
Tighten the brake flexible hose fitting.
Torque:
159 lb.in (18 Nm)
-
Bleed the brake system.
-
Install the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
Other information:
System Operation
Battery and Cables
Vehicles are equipped with a 12-volt, maintenance-free battery. The
battery is a 12V DC source connected in a negative ground system and is a
voltage stabilizer for the 12V electrical system.
A battery monitoring sensor is attached to the negative battery cable. Refer
to: Charging System - System Operation and Component Description
(414-00 Char..
U0100:87
Normal Operation and Fault Conditions
The BECMB uses information contained in messages from the PCM sent on the HS-CAN1 .
DTC Fault Trigger Conditions
DTC
Description
Fault Trigger Conditions
U0100:87
Lost Communication with ECM/PCM “A”: Missing Message
..