Ford Ecosport: Engine System - General Information / General Procedures - Piston Selection

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Engine System - General Information / General Procedures - Piston Selection

Check

NOTE: Refer to the appropriate Section 303-01 for the specifications.

NOTE: The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston.
- Measure the cylinder bore in 2 directions.
- Select a piston size based on the cylinder bore.

NOTE: For precision fit, new pistons are divided into 3 categories within each size range based on their relative position within the range. A paint spot or specific size grade on a new piston indicates the position within the size range.
Choose the piston with the correct paint color or specific size grade.

General Procedures - Piston Ring End Gap

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore...

General Procedures - Powertrain/Drivetrain Mount Neutralizing

Adjustment NOTE: Refer to the appropriate section and procedure for special instructions on loosening and tightening mount fasteners. With the vehicle in NEUTRAL, position it on a hoist...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Wheel Bearing and Wheel Hub - Vehicles With: Rear Drum Brakes

Special Tool(s) / General Equipment 204-161 (T97P-1175-A) Installer, HalfshaftTKIT-1997-LM2TKIT-1997-F/FM2TKIT-1997-FLM2 204-348/3Remover/Installer, Wheel Hub/Wheel Bearing 205-D070 (D93P-1175-B) Remover, Front Wheel Hub 308-095Installer, Input Shaft Bearing 308-604Installer, Output Drive Flange Seal 308-643Installer, Input..

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Refrigerant System Tests - 2.0L Duratec-HE (129kW/175PS)

Inspection NOTE: Procedure 1 — Ambient Temperature between 21°C (70°F) and 38°C (100°F) NOTE: Variable compressors may not stroke up unless the ambient temperatures are above 21°C (70°F) when conducting the pressure mapping procedure. Variable compressor need to see a thermal load on the system in order to create normal operating pressures. Run the engine ..

Description and Operation - Health and Safety Precautions

General Service Warnings

Review carefully the information below before beginning any repair. Following these warnings is a list of specific system warnings that must be reviewed before beginning work on any listed system.

WARNING: Wear eye and ear protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.