Ford Ecosport: Front Disc Brake / Removal and Installation - Brake Caliper Anchor Plate
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the brake pads.
Refer to: Brake Pads (206-03 Front Disc Brake, Removal and Installation).
-
NOTE:
Make sure that new bolts are installed.
Remove the bolts and the brake caliper anchor plate. Discard the bolts.
Torque:
81 lb.ft (110 Nm)
Installation
-
To install, reverse the removal procedure.
WARNING:
Make sure that no load is placed on the brake hose.
Torque:
92 lb.ft (125 Nm)
Torque:
18 lb...
Materials
Name
Specification
Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C
-
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
B0001:11, B0001:12, B0001:13 and B0001:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver airbag stage 1 circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver airbag
If a fault is d..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The original equipment cellular phone antenna cable is part
of the wiring harness and cannot be removed. This procedure refers to
replacement of the cable only by overlaying the cable.
Remove the RH front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation..