Ford Ecosport: Exterior Trim and Ornamentation / Removal and Installation - Roof Rail
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
-
If equipped.
-
Rotate the cross member retainer nut counter clockwise and remove the retainer nut.
-
Remove the roof luggage carriers.
-
Using a non-marring trim tool, disengage retainer clips on the roof rail cover and remove the roof rail cover.
Use the General Equipment: Interior Trim Remover
-
Remove the roof rail bolts and remove the roof rail.
Torque:
53 lb.in (6 Nm)
-
Using a non-marring trim removal tool, remove the roof rail moulding.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
LH side shown, RH side similar.
Remove and discard the roof moulding.
Installation
NOTE:
Make sure that a new component is installed...
Other information:
General Specifications
Item
Specification
1.0L EcoBoost (92kW/125PS)
Rating
150 amps
Generator amps at
80.6
°F (
27
°C)
78 amps at 680 rpm (min) to 158 amps at 2,250 rpm (max)
Generator pulley ratio
2.65:1
Generator pulley r..
Removal
Remove the instrument panel.
Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation).
Disconnect the TCU antenna cable connector, remove the bolt and the TCU antenna.
Installation
To install, reverse the removal procedure.
..