Ford Ecosport: Exterior Lighting / Removal and Installation - High Mounted Stoplamp
Removal
-
NOTICE:
Washer fluid may escape.
Release the clips and remove the high mounted stop lamp.
-
Disconnect the electrical connector.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Liftgate reflector
NOTE:
LH rear lamp assembly shown...
Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore...
B11CF:11, B11CF:12, B11CF:13, B11CF:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger airbag adaptive canister vent circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger airbag adapt..