Ford Ecosport: Handles, Locks, Latches and Entry Systems / Description and Operation - Handles, Locks, Latches and Entry Systems - Overview
Overview
The handles, locks, latches, and entry systems consist of the following:
Main Components:
-
BCM
-
DDM (with passenger door one-touch windows)
-
Door latches
-
Door lock control switches
-
DRDM (with passenger door one-touch windows)
-
Exterior front door handles containing lock/unlock sensors
-
Horn
-
IKT (without passenger door one-touch windows)
-
Keyless entry antennas
-
Lock actuators
-
Passive key (with passenger door one-touch windows)
-
PCM
-
PDM (with passenger door one-touch windows)
-
PRDM (with passenger door one-touch windows)
Main Features:
-
Autolock
-
Auto-unlock
-
Fuel filler door lock (if equipped)
-
Panic alarm
-
Passive entry (if equipped)
-
Power door locks
-
RKE )
The
power door lock/unlock feature locks or unlocks the doors, tailgate,
and fuel filler door (if equipped) upon a request from an interior door
lock control switch, passive entry system (if equipped), valid
programmed key (RKE
transmitter), or mechanical key in the driver door lock cylinder. The
power door locking system functions independently of the ignition status
or vehicle speed.
The tailgate comes equipped with either a manual or electronic lock.
If
equipped with a fuel filler door lock, the fuel filler door lock
operates when the driver door lock is electronically activated.
System Operation
System Diagram
Item
Description
1
RKE Antenna
2
Passive Key
3
With Push-Button Start
4
RKE Commands
5
BCM
6
IKT Key
7
Without Push-Button Start
8
RKE Commands
9
Passive Entry Commands
10
Fuel Filler Door Lock Actuator
11
Rear Door Lock Cont..
Other information:
Special Tool(s) /
General Equipment
204-167Compressor, Coil Spring
204-167-01Adapter for 204-167
Transmission Jack
Vehicle/Axle Stands
Interior Trim Remover
Removal
NOTICE:
Suspension fasteners are critical parts that affect the
performance of vital components and systems. Failure of these fasteners
may result in major service ..
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual. Failure to follow this
instruction may result in incorrect operation of the seatbelt system and
increase the risk of se..