Ford Ecosport: Handles, Locks, Latches and Entry Systems / Description and Operation - Handles, Locks, Latches and Entry Systems - Component Location

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Handles, Locks, Latches and Entry Systems / Description and Operation - Handles, Locks, Latches and Entry Systems - Component Location

Item	Description
1	BCM
2	Keyless entry rear antenna
3	LHF exterior door handle keyless entry antenna ( RHF also shown)

Handles, Locks, Latches and Entry Systems

Description and Operation - Handles, Locks, Latches and Entry Systems - Overview

Overview The handles, locks, latches, and entry systems consist of the following: Main Components: BCM DDM (with passenger door one-touch windows) Door latches Door lock control switches DRDM (with passenger door one-touch windows) Exterior front door handles containing lock/unlock sensors Horn IKT (without pass..

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Halfshaft Seal LH

Special Tool(s) / General Equipment 205-153 (T80T-4000-W) Handle 307-626Installer, Differential SealTKIT-2008ET-FLMTKIT-2008ET-ROW Puller Punch Removal Remove the LH halfshaft. Poke a small hole in the halfshaft seal. Use the General Equipment: Punch ..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Accelerator Pedal

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: To prevent setting Diagnostic Trouble Codes (DTCs), make sure that the Transmission shifter is in P position (Parking). NOTE: Make sure the ignition switch is in the OFF position for at least 30 seconds, prior to disconnect the accelerator pedal electrical connector. ..

Removal and Installation - Front Stabilizer Bar

Special Tool(s) / General Equipment

Tie Rod End Remover Transmission Jack

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Disconnect the b