Ford Ecosport: Exterior Trim and Ornamentation / Removal and Installation - Roof Moulding
Removal
NOTE:
LH side shown, RH side similar.
-
Remove and discard the roof moulding.
Installation
-
NOTE:
Make sure that a new component is installed.
Install the roof moulding.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH side shown, RH side similar.
Remove the front fender moulding...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Make sure all cylinder head surfaces are clear of
any gasket material, silicone sealant, oil and coolant...
Special Tool(s) /
General Equipment
Cable Ties
Removal
NOTE:
If the catalytic converter is not being replaced, the HO2S
and the catalyst monitor sensor do not need to be removed from the
catalytic converter. Disconnecting the electrical connectors is still
necessary...