Ford Ecosport: Rear Drive Axle/Differential / Removal and Installation - Rear Halfshaft Seal

Ford Ecosport 2014-2026 Service and Repair Manual / Driveline / Rear Drive Axle/Differential / Removal and Installation - Rear Halfshaft Seal

Special Tool(s) / General Equipment

	205-153 (T80T-4000-W) Handle
	205-990 Installer, Axle Seal TKIT-2012A-FL TKIT-2012A-ROW

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the rear halfshaft.
Refer to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation).

NOTE: There is no bearing for the stud shaft. There is a seal only.
Remove the rear halfshaft seal.

Installation

Using the special tools, install the rear halfshaft seal.
Use Special Service Tool: 205-153 (T80T-4000-W) Handle. , 205-990 Installer, Axle Seal.

Install the rear halfshaft.
Refer to: Rear Halfshaft (205-05 Rear Drive Halfshafts, Removal and Installation).

Check the differential fluid level.
Refer to: Differential Fluid Level Check (205-02 Rear Drive Axle/Differential, General Procedures).

Removal and Installation - Differential Rear Bushing

Special Tool(s) / General Equipment 204-598-01Remover/Installer, Subframe Bushing Guide 205-271Installer, Pivot Bushing Transmission Jack Removal With the vehicle in NEUTRAL, position it on a hoist...

Front Drive Halfshafts

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Anti-Theft Key Programming - Scan Tool

Programming NOTE: A passive key with a depleted battery(ies) only starts the vehicle when in the backup starting location. The RKE functionality remains inoperative until the key battery(ies) is replaced. NOTE: The diagnostic scan tool must have an active Internet connection. A hardwired connection is strongly recommended. NOTE: When programming keys, the RKE transmitter a..

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AH, Vehicles With: Rear Seat Side Airbag

U0154:00 Normal Operation and Fault Conditions The RCM uses information contained in messages from the OCSM sent on the HS-CAN2 . DTC Fault Trigger Conditions DTC Description Fault Trigger Conditions U0154:00 Lost Communication with Restraints Occupant Classification System..

Removal and Installation - Front Stabilizer Bar

Special Tool(s) / General Equipment

Tie Rod End Remover Transmission Jack

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Disconnect the b