Ford Ecosport: Anti-Lock Brake System (ABS) and Stability Control / Removal and Installation - Rear Wheel Speed Sensor - 4WD
Removal
NOTE: Removal steps in this procedure may contain installation details.
NOTE: Note the position of the rear wheel speed sensor before removal.
-
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
-
Disconnect the electrical connector and detach the wiring retainers.
 |
-
NOTICE: Make sure that the area around the component is clean and free of foreign material.
Detach the wiring retainer, remove the bolt and the rear wheel speed sensor.
Torque: 71 lb.in (8 Nm)
 |
Installation
-
NOTE: Make sure that this component is installed to the noted removal position.
To install, reverse the removal procedure.
Removal and Installation - Hydraulic Control Unit (HCU)
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
A new HCU is equipped with a new ABS module.
NOTE:
The PMI process must begin with the current ABS module installed...
Removal and Installation - Rear Wheel Speed Sensor - FWD
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Note the position of the rear wheel speed sensor before removal...
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Fuel Tank and Lines
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P008A:00 Low Pressure Fuel System Pressure - Too Low: No Sub Type Information GO to Pinpoint Test HC ..
Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Temperature Door Actuator
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the climate control housing. Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation). Remove the retainers and the temperature door actuator. Installation To ..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- General Procedures - Battery Charging
- Body and Paint
- Diagnosis and Testing - Body Control Module (BCM)
- Removal and Installation - Starter Motor
- Removal and Installation - Front Seat
Removal and Installation - Front Stabilizer Bar
Special Tool(s) / General Equipment
Tie Rod End Remover Transmission JackRemoval
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
NOTICE: Disconnect the b
