Ford Ecosport Owners and Service Manuals

Ford Ecosport: Climate Control System - General Information / Removal and Installation - Temperature Door Actuator

Ford Ecosport 2014-2026 Service and Repair Manual / Climate Control System / Climate Control System - General Information / Removal and Installation - Temperature Door Actuator

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the climate control housing.
    Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation).
  1. Remove the retainers and the temperature door actuator.

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Sunload Sensor

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the sunload sensor and disconnect the electrical connector...

    Removal and Installation - Thermostatic Expansion Valve

    Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Turn Signal and Hazard Lamps


    DTC Chart: BCM Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   BCM DTC Chart   DTC Description Action B123A:11 Left Front Tu..

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Door Upper Moulding


    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Lower the door window glass. Rear door moulding type 1 Remove the upper belt moulding screw at front of the door. Using a non-marring trim too..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com