Ford Ecosport: Exterior Lighting / Removal and Installation - Trailer Module (TRM)
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the diagnostic scan tool
prior to removing the module. This information must be downloaded into
the new module after installation.
Carry out the PMI procedure for the TRM .
Refer to: Module Programming (418-01 Module Configuration, General Procedures).
-
Position the second row seat cushion upwwards.
-
Remove the nuts and the trailer module.
-
Disconnect the electrical connectors.
Torque:
48 lb.in (5.4 Nm)
Installation
-
To install, reverse the removal procedure.
-
Using the previous diagnostic scan tool session, carry out the PMI procedure for the TRM .
Refer to: Module Programming (418-01 Module Configuration, General Procedures).
Removal
NOTICE:
Do not press, pull or otherwise move the brake pedal
while installing the stoplamp switch and cruise control deactivation
switch...
Other information:
System Operation
Air Fuel Ratio Imbalance Monitor
The air fuel ratio imbalance monitor is an on board diagnostic strategy designed to monitor the air fuel ratio.
Air Fuel Ratio Imbalance Monitor — Heated Oxygen Sensor (HO2S) Monitor
The air fuel ratio imbalance monitor estimates the cylinder to
cylinder air fuel ratio difference using the universal HO2S
high frequency signal. T..
Special Tool(s) /
General Equipment
211-001
(TOOL-3290-D)
Remover, Tie-Rod End
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
NOTICE:
Make sure that a new nut is installed.
Re..