Ford Ecosport: Climate Control System - General Information / Removal and Installation - Sunload Sensor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the sunload sensor and disconnect the electrical connector.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the condenser.
Refer to: Condenser - 1.5L Duratec (90kW/120PS) – I3 (412-00 Climate
Control System - General Information, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Other information:
Sound Deadeners and Insulators
NOTICE:
Mastic is made of a combustible material and should be
removed prior to carrying out welding procedures to the area. Heat zones
from welding near mastic may cause the mastic material to burn.
NOTICE:
Corrosion protection must be restored to the area after the
mastic material is applied...
Check
NOTE:
No factory-equipped vehicle should have more than a 25 mA
(0.025 amp) – 50 mA (0.050) draw depending on the vehicle's accessories.
Check for current drains on the battery in excess of 25 mA (0.025 amp) –
50 mA (0.050) with all the electrical accessories off and the vehicle
at rest for at least 75 minutes (depending on region)...