Ford Ecosport Owners and Service Manuals

Ford Ecosport: Rear Disc Brake / Removal and Installation - Brake Disc Shield

Ford Ecosport 2014-2026 Service and Repair Manual / Brake System / Rear Disc Brake / Removal and Installation - Brake Disc Shield

Removal

Vehicles With: FWD

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the wheel hub.
    Refer to: Wheel Hub - Vehicles With: Rear Disc Brakes (204-02A Rear Suspension - FWD, Removal and Installation).
  1. Remove the brake disc shield.

Vehicles With: AWD

  1. Remove the wheel bearing and wheel hub.
    Refer to: Wheel Bearing and Wheel Hub - Vehicles With: Rear Disc Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
  1. Remove the bolts and the brake disc shield.
    Torque: 80 lb.in (9 Nm)

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Brake Disc

    Materials Name Specification Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C -  Removal NOTE: Removal steps in this procedure may contain installation details...

    Removal and Installation - Brake Pads

    Special Tool(s) / General Equipment Brake Caliper Piston Retractor Materials Name Specification Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake FluidPM-20 WSS-M6C65-A2  Multi-Purpose Grease WSS-M12A4-A2  Removal NOTE: Removal steps in this procedure may contain installation details...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Diagnostic Strategy


    Overview The diagnostic process for each transmission concern will vary depending on the symptoms and condition of the vehicle. The diagnostic process below is an efficient method to collect as much data as possible about the concern before performing a repair or removing the transmission from the vehicle for teardown and further inspection...

    Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Compression and Cylinder Leakage Test


    Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged. Operate the vehicle until the engine is at normal operating temperature. Turn the ignition switch to the OFF position...

    Categories

    Removal and Installation - Rear Halfshaft Seal

    Special Tool(s) / General Equipment

    205-153 (T80T-4000-W)
    Handle 205-990
    Installer, Axle Seal
    TKIT-2012A-FL
    TKIT-2012A-ROW

    read more

    Copyright © 2026 www.foecosport2.com