Ford Ecosport: Interior Trim and Ornamentation / Removal and Installation - Liftgate Trim Panel
Removal
-
Remove the liftgate trim panel screws.
-
Release the pin-type retainers and locator pins and remove the liftgate trim panel.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
RH shown, LH similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the D-pillar trim panel...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
LH shown, RH similar.
Release the clips and remove the rear door sail panel...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component.
NOTE:
The PMI process must begin with the current SCCM installed. If the
current SCCM does not respond to the diagnostic scan tool, the tool may
prompt for As-Built data as part of the repair...
B1417:11, B1417:12, B1417:13, B1417:96
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM monitors the RH front impact severity sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Faulted RH front impact severity sensor
If a fault is..