Ford Ecosport Owners and Service Manuals

Ford Ecosport: Climate Control System - General Information / Removal and Installation - Blower Motor

Ford Ecosport 2014-2026 Service and Repair Manual / Climate Control System / Climate Control System - General Information / Removal and Installation - Blower Motor

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the brake pedal and bracket assembly.
    Refer to: Brake Pedal and Bracket (206-06 Hydraulic Brake Actuation, Removal and Installation).
  1. Disconnect the electrical connector, remove the retainers and the blower motor.

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Ambient Air Temperature Sensor

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the front bumper cover. Remove the ambient air temperature sensor...

    Removal and Installation - Blower Motor Speed Control

    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Fuel Charging


    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P0201:00 Cylinder 1 Injector 'A' Circuit/Open: No Sub Type Information GO to Pinpoint Test DI P..

    Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Supplemental Climate Control - System Operation and Component Description


    System Operation System Diagram Item Description 1 HVAC control module 2 GWM 3 PCM 4 Electric booster heater 5 Ambient Air Temperature (AAT) sensor 6 ECT sensor 7 Electric booster heater relays Network Message Charts   Module Network ..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com