Ford Ecosport: Climate Control System - General Information / Removal and Installation - Ambient Air Temperature Sensor
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the front bumper cover.
-
Remove the ambient air temperature sensor.
-
Disconnect the electrical connector.
-
Detach and remove the ambient air temperature sensor.
Installation
-
To install, reverse the removal procedure.
-
If replacing the ambient air temperature sensor a reset must be performed.
Refer to: Reset the Outside Air Temperature Sensor Learned Values
(412-00 Climate Control System - General Information, General
Procedures).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the passenger glove compartment.
Refer to: Glove Compartment (501-12 Instrument Panel and Console, Removal and Installation)...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the brake pedal and bracket assembly.
Refer to: Brake Pedal and Bracket (206-06 Hydraulic Brake Actuation, Removal and Installation)...
Other information:
Removal
NOTE:
The fuel pump driver module is located under the left front
carpet, attached to the rear of the front floor cross support in front
of the left front seat.
Vehicles with a carpet access flap
Move the left front seat to the full rear position...
Removal
Vehicles without overhead console
Position the microphone.
Disconnect and remove the microphone.
Vehicles with overhead console
Remove the overhead console...