Ford Ecosport Owners and Service Manuals

Ford Ecosport: Parking Aid / Removal and Installation - Rear Parking Aid Sensor

Ford Ecosport 2014-2026 Service and Repair Manual / Instrumentation and Warning Systems / Parking Aid / Removal and Installation - Rear Parking Aid Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the rear bumper cover.
    Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
  1. Disconnect the rear parking aid sensor electrical connector(s).

    1. Release the tabs.
    1. Remove the rear parking aid sensor(s).

Installation

  1. Install the rear parking aid sensor(s).
  1. Connect the rear parking aid sensor electrical connector(s).
  1. Install the rear bumper cover.
    Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).
  1. Carry out the azimuth and elevation system checks.
    Refer to: Azimuth System Check (413-13A Parking Aid, General Procedures).
    Refer to: Elevation System Check (413-13A Parking Aid, General Procedures).
  1. If any sensor fails a system check, diagnose the rear parking aid system.
    Refer to: Parking Aid (413-13A Parking Aid, Diagnosis and Testing).

    Removal and Installation - Parking Assist Control Module (PAM)

    Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module...

    Parking Aid - Vehicles With: Parking Aid Camera

    ..

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - High Mounted Stoplamp


    Removal NOTICE: Washer fluid may escape. Release the clips and remove the high mounted stop lamp. Disconnect the electrical connector. Installation To install, reverse the removal procedure. ..

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Muffler and Tailpipe - LHD 4WD


    Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). Remove and discard the muffler and catalytic converter flange clamp. ..

    Categories

    Removal and Installation - Front Brake Flexible Hose

    Removal

    Remove the wheel and tire.
    Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

    Remove the brake flexible hose bracket bolt.
    Disconnect the brake tube fitting and remove the brake hose clip.
    Loosen the brake hose fitting and remove the brake flexible hose.

    read more

    Copyright © 2026 www.foecosport2.com