Ford Ecosport: Fuel Charging and Controls - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Fuel Injectors
Removal and Installation
-
The fuel injectors are removed with the fuel rail.
Refer to: Fuel Rail (303-04C Fuel Charging and Controls - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
Removal
NOTE:
The fuel pump driver module is located under the left front
carpet, attached to the rear of the front floor cross support in front
of the left front seat...
Other information:
Removal
NOTICE:
During the removal of components, cap, tape or otherwise
appropriately protect all openings to prevent the ingress of dirt or
other contamination. Remove protective materials prior to installation.
NOTE:
Removal steps in this procedure may contain installation details...
B1404:11, B1404:12, B1404:13, B1404:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver side airbag circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver side airbag
If a fault is d..