Ford Ecosport: Information and Entertainment System - General Information / Removal and Installation - Audio Unit Antenna
Removal
-
Lower the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the audio unit antenna.
-
Disconnect the antenna cable.
-
Remove the audio unit antenna base bolt.
-
Remove the audio unit antenna retaining bracket.
Installation
-
NOTE:
If installing a new audio unit antenna it is not
necessary to remove the bolt from the audio unit antenna base.
Install harness through the opening and push the antenna until the base is fully seated.
-
Connect the audio unit antenna connector.
-
Install the headliner.
Refer to: Headliner - Lowering (501-05 Interior Trim and Ornamentation, Removal and Installation).
Removal
Position the rear seat cushion to the full forward position.
Position the carpet flap forward...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
The original equipment audio unit antenna cable is part of
the wiring harness and cannot be removed...
Other information:
Special Tool(s) /
General Equipment
303-096
(T74P-6150-A)
Installer, Camshaft Front Oil SealTKIT-2009TC-F
303-409
(T92C-6700-CH)
Remover, Crankshaft SealTKIT-1992-FH/FMH/FLMHTKIT-1993-LMH/MH
Removal
NOTICE:
Do not loosen or remove the crankshaft pulley bolt without
first installing the special tools as instructed in this procedure...
Removal
NOTICE:
Do not loosen any fittings or plugs on the high-pressure fuel pump.
Release the fuel system pressure.
Refer to: Fuel System Pressure Release (310-00C Fuel System - General
Information - 2.0L Duratec-HE (129kW/175PS), General Procedures)...