Ford Ecosport Owners and Service Manuals

Ford Ecosport: Wipers and Washers / Removal and Installation - Windshield Wiper Pivot Arm

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Wipers and Washers / Removal and Installation - Windshield Wiper Pivot Arm

Special Tool(s) / General Equipment

Two Leg Puller

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the cap.
  1. Remove the nut.
    Torque: 18 lb.ft (25 Nm)
  1. Using a puller, remove the windshield wiper pivot arm.
    Use the General Equipment: Two Leg Puller

Installation

  1. NOTE: Make sure the wiper blade ends are aligned with the dots on the windshield.

    To install, reverse the removal procedure.

    Removal and Installation - Windshield Wiper Motor

    Removal NOTE: The wiper motor and linkage are serviced as an assembly. Remove the wiper linkage assembly. Refer to: Wiper Linkage Assembly (501-16 Wipers and Washers, Removal and Installation)...

    Removal and Installation - Wiper Linkage Assembly

    Removal NOTICE: Make sure that the wiper motor is in the park position. NOTE: Removal steps in this procedure may contain installation details...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Valve Cover


    Special Tool(s) / General Equipment 205-153 (T80T-4000-W) Handle 303-1247VCT Spark Plug Tube Seal Remover and InstallerTKIT-2006UF-FLMTKIT-2006UF-ROW Plastic Scraper Materials Name Specification Motorcraft® Silicone Gasket and SealantTA-30 WSE-M4G323-A4  Removal NOTICE: During engine repair procedures, cleanli..

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Brake Pedal and Bracket


    Special Tool(s) / General Equipment Flat-Bladed Screwdriver Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LHD shown, RHD similar. Remove the driver knee airbag. Refer to: Driver Knee Airbag (501-20B Supplemental Restraint System, Removal and Installation). 1.5L/2.0L ..

    Categories

    Removal and Installation - Wheel Knuckle Bushing

    Special Tool(s) / General Equipment

    Hydraulic Press

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the wheel knuckle.
    Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
    Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
    Torque:
      Stage 1:  177 lb.in (20 Nm)
      Stage 2:  76 lb.ft (103 Nm)

    read more

    Copyright © 2026 www.foecosport2.com