Ford Ecosport: Wipers and Washers / Removal and Installation - Wiper Linkage Assembly
Removal
NOTICE:
Make sure that the wiper motor is in the park position.
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the cowl panel.
Refer to: Cowl Panel (501-02 Front End Body Panels, Removal and Installation).
-
Disconnect the windshield wiper motor electrical connector.
-
Remove the bolts and the wiper linkage and motor as an assembly.
Torque:
53 lb.in (6 Nm)
Installation
-
To install, reverse the removal procedure.
-
Before installing the wiper arms, turn the ignition
ON and then switch the wipers to LOW and then OFF to assure the wiper
spindles are in the PARK position.
Special Tool(s) /
General Equipment
Two Leg Puller
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the liftgate trim panel.
Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Disconnect the electrical connector and remove the grommet.
Remove the nuts.
Torque:
35 lb.in (4 Nm)
..
Special Tool(s) /
General Equipment
Knife
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front bumper cover.
Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation).
NOTE:
LH side only.
Detach the retainer and position the wiring harness aside.
..