Ford Ecosport: Engine System - General Information / General Procedures - Cylinder Block Distortion

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Engine System - General Information / General Procedures - Cylinder Block Distortion

Special Tool(s) / General Equipment

Feeler Gauge

Check

NOTE: Refer to the appropriate Section 303-01 for the specification.

NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.
Use a Straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.
Use the General Equipment: Feeler Gauge

General Procedures - Cylinder Block Core Plug Replacement

Special Tool(s) / General Equipment 100-001 (T50T-100-A) Slide Hammer Materials Name Specification Motorcraft® Threadlock 262TA-26 WSK-M2G351-A6 Repair All core plugs NOTE: Cylinder block core plug shown, cylinder head core plug similar...

General Procedures - Cylinder Bore Taper

Check NOTE: Refer to the appropriate Section 303-01 for the specification. Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Pump Assembly

Fluid Pump and Transmission Fluid Filter Components Item Description 1 Torque converter 2 Torque converter housing 3 Transmission fluid filter 4 Pump assembly 5 Pump-to-torque converter housing bolt 6 Tr..

Ford Ecosport 2014-2026 Service and Repair Manual: Specifications

Materials Name Specification Motorcraft® SAE 80W-90 Premium Rear Axle Lubricant WSP-M2C197-A Capacities Item Liters Motorcraft® SAE 80W-90 Premium Rear Axle Lubricant 0.47-0.62L (1.0-1.3 Pt) (to the bottom of the fil..

Removal and Installation - Front Brake Flexible Hose

Removal

Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Remove the brake flexible hose bracket bolt.
Disconnect the brake tube fitting and remove the brake hose clip.
Loosen the brake hose fitting and remove the brake flexible hose.