Ford Ecosport: Engine System - General Information / General Procedures - Cylinder Bore Taper

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Engine System - General Information / General Procedures - Cylinder Bore Taper

Check

NOTE: Refer to the appropriate Section 303-01 for the specification.

Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. If the cylinder bore taper does not meet specification, bore the cylinder to the next oversize limit.

General Procedures - Cylinder Block Distortion

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0...

General Procedures - Cylinder Head Distortion

Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Make sure all cylinder head surfaces are clear of any gasket material, silicone sealant, oil and coolant...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Reversing Lamp

Removal NOTE: RH side reversing lamp assembly shown, LH side similar. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). Disconnect the electrical connector...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Axle Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear subframe - AWD. Refer to: Rear Subframe - AWD (502-00 Uni-Body, Subframe and Mounting System, Removal and Installation). Remove the bolts and the RDU front mounting brackets...

Removal and Installation - Brake Disc Shield

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the brake disc.
Refer to: Brake Disc (206-03 Front Disc Brake, Removal and Installation).
Remove the bolts and brake disc.
Torque: 80 lb.in (9 Nm)