Ford Ecosport: Handles, Locks, Latches and Entry Systems / Removal and Installation - Hood Latch Release Handle
Ford Ecosport 2014-2025 Service and Repair Manual / Body and Paint / Handles, Locks, Latches and Entry Systems / Removal and Installation - Hood Latch Release Handle
Removal
-
Remove the LH instrument panel trim cover.
 |
-
Remove the hood latch release handle.
-
Release the hood latch release handle retaining tabs from the instrument panel.
-
Release the hood latch release cable from the hood latch release handle mounting bracket.
-
Remove the hood latch release cable eyelet from the hood latch release handle.
-
Release the hood latch release handle retaining tabs from the instrument panel.
 |
Installation
-
To install, reverse the removal procedure.
Removal and Installation - Hood Latch Release Cable
Removal
Remove the air cleaner.
Refer to: Air Cleaner (303-12A Intake Air Distribution and Filtering - 1.0L EcoBoost (92kW/125PS), Removal and Installation)...
Removal and Installation - Ignition Lock Cylinder
Removal
NOTE:
LHD shown, RHD similar.
Non-functional lock cylinder
Replace the steering column lock and ignition switch housing...
Other information:
Ford Ecosport 2014-2025 Service and Repair Manual: Removal and Installation - Back Panel and Reinforcement
Special Tool(s) / General Equipment Resistance Spotwelding Equipment Spot Weld Drill Bit Locking Pliers Materials Name Specification Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM - Removal Restore the vehicle to pre-accident dimensions, if required...
Ford Ecosport 2014-2025 Service and Repair Manual: Specifications
General Specifications Item Specification Plastic front fascia paint maximum thickness 12 mils (300 microns) Plastic rear fascia paint maximum thickness 12 mils (300 microns) General Specifications Item..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2025)
- General Procedures - Transmission Fluid Level Check
- Removal and Installation - Fuel Pump and Sender Unit
- Diagnosis and Testing - Body Control Module (BCM)
- Removal and Installation - Body Control Module (BCM)
- Automatic Transmission - 6-Speed Automatic Transmission – 6F35
Removal and Installation - Steering Column Shaft
Removal
NOTE: Removal steps in this procedure may contain installation details.
NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the steering column internal sensor may result.
NOTE: Use a steering wheel holding device (such as Hunter® 28-75-1 or equivalent)
Hold the steering wheel in the straight-ahead position.
Copyright © 2025 www.foecosport2.com