Ford Ecosport: Roof Opening Panel / Removal and Installation - Trough Assembly
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the roof opening panel glass.
Refer to: Roof Opening Panel Glass (501-17 Roof Opening Panel, Removal and Installation).
-
Remove the roof opening panel frame.
Refer to: Roof Opening Panel Frame (501-17 Roof Opening Panel, Removal and Installation).
-
On both sides.
Pull out the trough arm to disconnect from the trough assembly.
-
On both sides.
Slide the trough and the shield backward upto notches in the rear of the frame.
-
On both sides.
-
Align the trough retaining tab with notches in the rear of the frame.
-
Lift the trough assembly upwards towards the front and remove out of the guides.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the trough assembly.
Refer to: Trough Assembly (501-17 Roof Opening Panel, Removal and Installation)...
Other information:
Deactivation
NOTE:
During vehicle build, some modules, such as the IPC and BCM are set in factory mode.
Factory mode reduces the drain on the battery during longer periods
where the vehicle is not used. While in the factory mode, various
systems may be altered or disabled and the IPC
displays FACTORY MODE CONTACT DEALER in the message center. If the
vehicle is in factory mo..
Removal
Remove the A-pillar trim panel.
Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
Release the tabs and remove the A-pillar tweeter speaker.
Installation
To install, reverse the removal procedure.
..