Ford Ecosport: Roof Opening Panel / Removal and Installation - Roof Opening Panel Shield

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Roof Opening Panel / Removal and Installation - Roof Opening Panel Shield

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the trough assembly.
Refer to: Trough Assembly (501-17 Roof Opening Panel, Removal and Installation).

On both sides.
Remove the rear sun shield stops.

On both sides.
Slide the sun shield rearward and remove from the rear of the roof opening panel frame.

Installation

To install, reverse the removal procedure.

Removal and Installation - Roof Opening Panel Rear Drain Hose

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the rear bumper cover...

Removal and Installation - Trough Assembly

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the roof opening panel glass. Refer to: Roof Opening Panel Glass (501-17 Roof Opening Panel, Removal and Installation)...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Staged Unlock Programming

Programming WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Output Shaft Speed (OSS) Sensor

Removal Remove the main control valve body. Refer to: Main Control Valve Body (307-01B Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Removal and Installation). Remove the OSS sensor bolt and the OSS sensor...

Removal and Installation - Front Stabilizer Bar

Special Tool(s) / General Equipment

Tie Rod End Remover Transmission Jack

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

NOTICE: Disconnect the b