Ford Ecosport: Evaporative Emissions - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Evaporative Emission Blocking Valve

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Evaporative Emissions - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Evaporative Emission Blocking Valve

Removal

NOTE: The evaporative emission blocking valve is serviced with the fuel tank pressure sensor and tube.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).

- Detach the retainer & remove the EVAP blocking valve electrical connector.
- Release the quick connect couplings and remove the EVAP blocking valve.
  Refer to: Quick Release Coupling (310-00A Fuel System - General Information - 1.0L EcoBoost (92kW/125PS), General Procedures).

Installation

To install, reverse the removal procedure.

General Procedures - Evaporative Emission System Leak Test

Activation Phase 1 - Leak Verification Run the EVAP Test with the scan tool. NOTE: Some small leaks may not be detected using the EVAP Test...

Removal and Installation - Evaporative Emission Canister

Removal WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Horn

DTC Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). BCM DTC Chart DTC Description Actions B1323:11 Horn Switch: Circuit S..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Roof Opening Panel Control Switch

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. Remove the roof opening panel control switch and disconnect the electrical connector. Use the General Equipment: Interior Trim Remover Installation To install, reverse ..

Removal and Installation - Oil Pressure Switch

Materials

Name Specification Motorcraft® Thread Sealant with PTFE
TA-24-B WSK-M2G350-A2

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.