Ford Ecosport Owners and Service Manuals

Ford Ecosport: Climate Control System - General Information / Removal and Installation - Evaporator

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the climate control housing.
    Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation).
  1. Remove the retainers and remove the cabin air filter cover.
  1. Detach the harness retainer for the evaporator temperature sensor, remove the retainers and the climate control housing bracket.
  1. Remove the retainers and the evaporator cover, remove the evaporator.

Installation

  1. To install, reverse the removal procedure.

    Removal and Installation - Driver Side Register

    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details...

    Removal and Installation - Evaporator Inlet and Outlet Manifold - 2.0L Duratec-HE (129kW/175PS)

    Removal NOTICE: During the removal of components, cap, tape or otherwise appropriately protect all openings to prevent the ingress of dirt or other contamination...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Supplemental Restraint System (SRS) Repowering


    Repower   WARNING: Incorrect repair techniques or actions can cause an accidental Supplemental Restraint System (SRS) deployment. Never compromise or depart from these instructions. Failure to precisely follow all instructions could result in serious personal injury from an accidental deployment...

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Communications Network


    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   Diagnostic Trouble Code Chart Module   DTC Description Action ..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com