Ford Ecosport: Climate Control System - General Information / Removal and Installation - Driver Side Register
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Release the clips and remove the driver side register.
Use the General Equipment: Interior Trim Remover
Installation
-
To install, reverse the removal procedure.
Removal
NOTICE:
During the removal of components, cap, tape or otherwise
appropriately protect all openings to prevent the ingress of dirt or
other contamination...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the climate control housing.
Refer to: Climate Control Housing (412-00 Climate Control System - General Information, Removal and Installation)...
Other information:
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
The crankshaft connecting rod journals must be
within specifications to check the connecting rod bearing journal
clearance.
Remove the connecting rod bearing cap and connecting rod bearing...
B1407:11, B1407:12, B1407:13, B1407:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the passenger side airbag circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted passenger side airbag
If a fault..