Ford Ecosport: Body and Paint / Side Panel Sheet Metal Repairs
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
Spherical Cutter
Hot Air Gun
Air Body Saw
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Removal
Depower the SRS ...
Other information:
B0050:11, B0050:12, B0050:13, B0050:1D
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver seatbelt buckle sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Current out of range
Faulted driver seatb..
Line Pressure Test
NOTE:
Perform the line pressure test prior to performing the stall
speed test. If the line pressure is low at stall, do not perform the
stall speed test or transmission damage will occur. Do not maintain WOT in any transmission range for more than 5 seconds.
This test verifies the line pressure is within specification.
Remove the 2 bolts and position as..