Ford Ecosport: Wipers and Washers / Removal and Installation - Windshield Washer Pump

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Wipers and Washers / Removal and Installation - Windshield Washer Pump

Materials

Name	Specification
Motorcraft® Premium Windshield Wash Concentrate with Bitterant ZC-32-B2	WSS-M14P19-A

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the windshield washer reservoir.
Refer to: Windshield Washer Reservoir (501-16 Wipers and Washers, Removal and Installation).

1. Disconnect the windshield washer pump fluid hoses.
1. Remove the windshield washer pump.

Installation

NOTICE: Do not operate the washer pump prior to filling the windshield washer reservoir. Failure to follow this instruction may result in premature pump failure.
To install, reverse the removal procedure.
Material: Motorcraft® Premium Windshield Wash Concentrate with Bitterant / ZC-32-B2 (WSS-M14P19-A)

Removal and Installation - Rear Window Wiper Pivot Arm

Special Tool(s) / General Equipment Two Leg Puller Removal NOTICE: Make sure that the motor is in the park position. NOTE: Removal steps in this procedure may contain installation details...

Removal and Installation - Windshield Washer Reservoir

Special Tool(s) / General Equipment Fluid Suction Gun Materials Name Specification Motorcraft® Premium Windshield Wash Concentrate with BitterantZC-32-B2 WSS-M14P19-A Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Air Distribution Door Actuator

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the brake pedal and bracket. Refer to: Brake Pedal and Bracket (206-06 Hydraulic Brake Actuation, Removal and Installation). Remove the steering column shrouds...

Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Accessory Drive - Component Location

Overview Item Description 1 Accessory drive belt tensioner 2 Coolant pump pulley 3 Generator pulley 4 Pulley - A/C compressor 5 Belt - A/C compressor 6 Crankshaft pulley 7 Accessory drive belt ..

Removal and Installation - Oil Pressure Switch

Materials

Name Specification Motorcraft® Thread Sealant with PTFE
TA-24-B WSK-M2G350-A2

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.