Ford Ecosport: Rear Drive Halfshafts / Specifications
Ford Ecosport 2014-2026 Service and Repair Manual / Driveline / Rear Drive Halfshafts / Specifications
RDU Lubricant
| Specification | Capacity |
|---|---|
| Motorcraft® SAE 80W-90 Premium Rear Axle Lubricant XY-80W90-QL (US); CXY-80W90-1L (Canada) Material: Motorcraft® SAE 80W-90 Premium Rear Axle Lubricant / XY-80W90-QL (WSP-M2C197-A) | 0.47L-0.62L (1.0-1.3 pt) |
Grease Specification
| Inner boot grease | Outer boot grease | ||
|---|---|---|---|
| Material | Capacity | Material | Capacity |
| Material: Grease (WSS-M1C272-A) | 127 g+10 g | Material: Grease (WSS-M13P13-A) | 85 g+10 g |
Diagnosis and Testing - Rear Drive Halfshafts
Preliminary Inspection
NOTE:
New rear drive halfshafts shall not be installed unless
disassembly and inspection reveals unusual wear of parts not available
in repair kits...
Other information:
Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Fuel Tank and Lines - System Operation and Component Description
System Operation Fuel Systems The fuel system supplies the fuel injectors with clean fuel at a controlled pressure. The PCM controls the fuel pump and monitors the fuel pump circuit. The PCM controls the fuel injector ON/OFF cycle duration and determines the correct timing and amount of fuel delivered...
Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Fuel Tank and Lines
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P008A:00 Low Pressure Fuel System Pressure - Too Low: No Sub Type Information GO to Pinpoint Test HC ..
Categories
- Manuals Home
- 2nd Gen Ford Ecosport Service Manual (2014 - 2026)
- Removal and Installation - Fuel Pump and Sender Unit
- Description and Operation - Jacking and Lifting - Overview
- General Procedures - Transmission Fluid Level Check
- Removal and Installation - Body Control Module (BCM)
- Automatic Transmission - 6-Speed Automatic Transmission – 6F35
Removal and Installation - Oil Pressure Switch
Materials
Name Specification Motorcraft® Thread Sealant with PTFETA-24-B WSK-M2G350-A2
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.
Copyright © 2026 www.foecosport2.com