Ford Ecosport: Wipers and Washers / Removal and Installation - Windshield Washer Reservoir

Special Tool(s) / General Equipment

Materials

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Using a suction gun, remove the windshield washer fluid from the reservoir.
   Use the General Equipment: Fluid Suction Gun

1. Remove the LH headlamp assembly.
   

1. If equipped.
   
   1. Detach the wiring harness retainers.
      
   2. Remove the pin type retainer.
      
   3. Remove the bolt and the engine air intake resonator.
      Torque: 27 lb.in (3 Nm)

1. Disconnect the hoses and remove the bolt.
   Torque: 27 lb.in (3 Nm)

1. Remove the LH fender splash shield.
   Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
   

1. Detach the wiring harness retainer.
   

1. 1. Disconnect the windshield washer pump electrical connector.
      
   2. Remove the lower windshield washer reservoir bolt and the windshield washer reservoir.
      Torque: 27 lb.in (3 Nm)
   3. Lift and detach the reservoir from the body.
      
   4. Lower and remove the windshield washer reservoir.
      

Installation

1. To install, reverse the removal procedure.
   Material: Motorcraft® Premium Windshield Wash Concentrate with Bitterant / ZC-32-B2 (WSS-M14P19-A)