Ford Ecosport: Engine Cooling - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Thermostat Housing

Special Tool(s) / General Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the RH headlamp.
   Refer to: Headlamp Assembly (417-01 Exterior Lighting, Removal and Installation).
   

1. Remove the accessory drive belt tensioner.
   Refer to: Accessory Drive Belt Tensioner (303-05C Accessory Drive - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
   

1. Drain the cooling system.
   Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03C Engine Cooling - 2.0L Duratec-HE (129kW/175PS), General Procedures).
   

1. NOTE: Cover the generator with waterproof plastic prior to removing the coolant hoses.

   Release the clamps and disconnect the coolant hoses.
   Use the General Equipment: Hose Clamp Remover/Installer

1. Remove the bolt, nuts and the crash bracket.
   Torque:
      1:   177 lb.in (20 Nm)
      2:   106 lb.in (12 Nm)

1. Remove the bolts and the thermostat housing. Inspect the O-ring seal and replace if necessary.
   Torque: 89 lb.in (10 Nm)

Installation

1. To install, reverse the removal procedure.