Ford Ecosport: Information and Entertainment System - General Information / Removal and Installation - SYNC Module [APIM]
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the IPC .
Refer to: Instrument Panel Cluster (IPC) (413-01 Instrumentation, Message Center and Warning Chimes, Removal and Installation).
-
Remove the APIM .
-
Disconnect the electrical connectors.
Installation
-
To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level.
Refer to: Module Programming (418-01 Module Configuration, General Procedures).
Removal
Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove components for access to the instrument panel wiring harness...
Other information:
NOTE:
This procedure uses multiple tools/methods to help locate the
source of engine noise. It may be necessary to repeatedly compare the
sound between the tools/methods to help locate the source of the noise.
NVH
symptoms should be identified using the diagnostic tools and techniques
that are available...
Special Tool(s) /
General Equipment
Surface Gauge
Check
Ride Height Measurement - Front
NOTE:
Make sure that the vehicle is positioned on a flat,
level surface and the tires are inflated to the correct pressure.
Vehicle should have a full tank of fuel...