Ford Ecosport: Information and Entertainment System - General Information / Removal and Installation - SYNC Module [APIM] to Universal Serial Bus (USB) Port Cable
Special Tool(s) /
General Equipment
Removal
-
Remove components for access to the instrument panel wiring harness.
-
Remove the IPC .
Refer to: Instrument Panel Cluster (IPC) (413-01 Instrumentation, Message Center and Warning Chimes, Removal and Installation).
-
Remove the HVAC control module.
Refer to: Heating, Ventilation and Air Conditioning (HVAC) Control
Module (412-00 Climate Control System - General Information, Removal and
Installation).
-
Remove the center air register.
Refer to: Center Registers (412-00 Climate Control System - General Information, Removal and Installation).
-
Disconnect the APIM to USB port cable from the APIM and cut the connector off the end of the cable.
-
Using a non-marring tool position the media hub out.
Use the General Equipment: Interior Trim Remover
-
Disconnect the APIM to USB port cable from the media hub and cut the connector off the end of the cable.
Installation
-
Overlay and secure the APIM to USB port cable to the instrument panel wiring harness using the routing shown.
-
Connect the APIM to USB port cable to the media hub and install the media hub.
-
Connect the APIM to USB port cable to the APIM .
-
Install the components removed components for access to the instrument panel wiring harness.
-
Install the center air register.
Refer to: Center Registers (412-00 Climate Control System - General Information, Removal and Installation).
-
Install the HVAC control module.
Refer to: Heating, Ventilation and Air Conditioning (HVAC) Control
Module (412-00 Climate Control System - General Information, Removal and
Installation).
-
Install the IPC .
Refer to: Instrument Panel Cluster (IPC) (413-01 Instrumentation, Message Center and Warning Chimes, Removal and Installation).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the IPC .
Refer to: Instrument Panel Cluster (IPC) (413-01 Instrumentation, Message Center and Warning Chimes, Removal and Installation)...
Removal
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Other information:
System Operation
System Diagram
Item
Description
1
RKE Antenna
2
Passive Key
3
With Push-Button Start
4
RKE Commands
5
BCM
6
IKT Key
7
Without Push-Button Start
8
RKE Commands
9
Passive Entry Commands
10
Fuel Filler Door Lock Actuator
11
Rear Door Lock Cont..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation.
Using a diagnostic scan tool, begin the PMI process for the PAM fol..