Ford Ecosport: Information and Entertainment System - General Information / Removal and Installation - Subwoofer Speaker

Ford Ecosport 2014-2026 Service and Repair Manual / Information and Entertainment Systems / Information and Entertainment System - General Information / Removal and Installation - Subwoofer Speaker

Removal

Remove the RH loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

Remove the screws, disconnect the electrical connector and remove the subwoofer speaker.

Installation

To install, reverse the removal procedure.

Removal and Installation - Rear Door Speaker

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Removal and Installation - SYNC Module [APIM]

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the IPC . Refer to: Instrument Panel Cluster (IPC) (413-01 Instrumentation, Message Center and Warning Chimes, Removal and Installation)...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Exterior Front Door Handle Reinforcement

Removal NOTE: LH side shown, RH side similar. Remove the front door latch. Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation). Remove the front door latch from the exterior front door handle reinforcement...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Parking Brake Control

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LHD shown, RHD similar. All vehicles Remove the floor console. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation)...

Removal and Installation - Oil Pressure Switch

Materials

Name Specification Motorcraft® Thread Sealant with PTFE
TA-24-B WSK-M2G350-A2

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.