Ford Ecosport: Automatic Transmission - 6-Speed Automatic Transmission – 6F35 / Removal and Installation - Selector Shaft Seal

Ford Ecosport 2014-2026 Service and Repair Manual / Automatic Transmission / Automatic Transmission - 6-Speed Automatic Transmission – 6F35 / Removal and Installation - Selector Shaft Seal

Special Tool(s) / General Equipment

	307-581 Manual lever seal installer TKIT-2006UF-FLM TKIT-2006UF-ROW
Flat Headed Screw Driver

Removal

Remove the TR sensor.
Refer to: Transmission Range (TR) Sensor (307-01B Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Removal and Installation).

Remove and discard the selector shaft seal.
Use the General Equipment: Flat Headed Screw Driver

Installation

Using the special tool, install the new selector shaft seal.
Use Special Service Tool: 307-581 Manual lever seal installer.

Install the TR sensor.
Refer to: Transmission Range (TR) Sensor (307-01B Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Removal and Installation).

Removal and Installation - Roll Restrictor RH

Removal With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

Removal and Installation - Solenoid

Special Tool(s) / General Equipment Long Nose Pliers Removal Using the scan tool Transmission Solenoid Identification Number (IDN) function, retrieve the solenoid base part number and stamping number...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: AE, Vehicles With: Rear Seat Side Airbag

BXXXX:2B, BXXXX:81 (any BXXXX DTC with a 2B failure type, or any impact sensor with an 81 failure type) Signal Cross Coupled Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM monitors all deployable device and sensor circuits for a signal cross coupled (short) between components...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Rear Window Wiper Pivot Arm

Special Tool(s) / General Equipment Two Leg Puller Removal NOTICE: Make sure that the motor is in the park position. NOTE: Removal steps in this procedure may contain installation details. Pivot the cover to access the wiper pivot arm nut...

Removal and Installation - Front Brake Flexible Hose

Removal

Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).

Remove the brake flexible hose bracket bolt.
Disconnect the brake tube fitting and remove the brake hose clip.
Loosen the brake hose fitting and remove the brake flexible hose.