Ford Ecosport: Supplemental Restraint System / Removal and Installation - Seat Position Sensor

Ford Ecosport 2014-2026 Service and Repair Manual / Body and Paint / Supplemental Restraint System / Removal and Installation - Seat Position Sensor

Removal

NOTE: LH power seat shown, other seats similar.

NOTE: Removal steps in this procedure may contain installation details.

1. Disconnect the electrical connector.
1. Remove the screw.
  Torque: 8 lb.in (0.9 Nm)
1. Remove the seat position sensor.

Installation

To install, reverse the removal procedure.

Removal and Installation - Restraints Control Module (RCM)

Removal WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash...

Removal and Installation - Seatbelt Minder Sensor

Special Tool(s) / General Equipment Hog Ring Plier Removal NOTE: Removal steps in this procedure may contain installation details...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Main Control Valve Body

Item Description 1 Transmission internal wiring harness frame 2 Main control valve body 3 Check balls (3 required) 4 Solenoid damper SSA 5 Solenoid body-to-valve body separator plate 6 ..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Spare Wheel Mounting Bracket

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the bolts and the spare wheel and tire. Torque: 41 lb.ft (55 Nm) Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the s..

Removal and Installation - Variable Camshaft Timing (VCT) Unit

Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

Remove the timing chain.
Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
Remove the bolts and VCT units.
Discard the bolts.