Ford Ecosport Owners and Service Manuals

Ford Ecosport: Automatic Transmission - 6-Speed Automatic Transmission – 6F35 / Description and Operation - Main Control Valve Body



Item Description
1 Transmission internal wiring harness frame
2 Main control valve body
3 Check balls (3 required)
4 Solenoid damper SSA
5 Solenoid body-to-valve body separator plate
6 Damper pistons and springs (3 required)
7 Elastomeric damper
8 Dowel pins (2 required)
9 Solenoid body
10 Solenoid retaining pin (14 required)
11 Manual valve
12 Solenoid pressure regulator valve assembly
13 Clutch bypass valve
14 TCC regulator valve
15 Control pressure regulator
16 Direct (3, 5, R) clutch regulator valve
17 Intermediate (2, 6) clutch regulator valve
18 Forward (1, 2, 3, 4) clutch regulator valve
19 Forward (1, 2, 3, 4) clutch latch valve
20 Low reverse/overdrive (4, 5, 6) clutch regulator valve
21 Direct (3, 5, R) clutch latch valve
22 Intermediate (2, 6) clutch latch valve
23 Low reverse/overdrive (4, 5, 6) clutch latch valve
24 LPC solenoid
25   SSC
26 TCC solenoid
27 SSE ON/OFF solenoid
28   SSA
29   SSB
30   SSD

Main Control Components

Item Description
1 Torque converter housing
2 Pump assembly
3 Transmission case
4 Main control-to-transmission case separator plate
5 Valve body
6 Solenoid body assembly
7 Main control cover

The main control assembly consists of a valve body and a solenoid body. Both the valve body and the solenoid body contain hydraulic shift valves. The solenoid body contains the shift solenoids that control the hydraulic valves. The solenoid body can be serviced as an assembly with the solenoids or the solenoids can be serviced individually. The solenoid body is controlled by the PCM . The PCM has software stored in it specific to the solenoid body currently in the transmission, called the solenoid body strategy. A new solenoid body strategy must be downloaded into the PCM anytime a new solenoid body is installed.

The pump assembly contains the main pressure regulator valve assembly and the TCC control valve assembly.

    Description and Operation - Torque Converter Clutch (TCC)

    TCC Hydraulic Circuits 1 Inspect the pump to transmission case hydraulic passages and seals. 2 Inspect the transmission case to main control hydraulic passages...

    Description and Operation - Pump Assembly

    Fluid Pump and Transmission Fluid Filter Components Item Description 1 Torque converter 2 Torque converter housing 3 Transmission fluid filter 4 Pump assembly 5 Pump-to-torque converter housing bolt 6 Tr..

    Other information:

    Ford Ecosport 2014-2025 Service and Repair Manual: General Procedures - Oil Pressure Test


    NOTE: It is necessary to disconnect the battery to avoid setting any DTCs that could cause the PCM to command the oil pressure to other than what should be observed from a correctly operating system during the oil pressure test. Disconnect the battery ground cable.For additional information, refer to: Battery Disconnect and Connect (414-01) . Remove the EO..

    Ford Ecosport 2014-2025 Service and Repair Manual: General Procedures - Seatbelt Minder Deactivating/Activating


    Activation   WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury. NOTE: The driver and passenger seat Belt-Minder® deactivating/activating can be carried out using the scan tool. NOTE: If you are using a MyKey® pr..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2025 www.foecosport2.com