Ford Ecosport: Exterior Lighting / Removal and Installation - Rear Lamp Bulb
Removal
Turn signal bulb
NOTE:
RH rear lamp assembly shown, LH rear lamp assembly similar.
-
Remove the rear lamp assembly.
Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation).
-
Remove the screws and the and the bulb holder.
-
Remove the turn signal bulb.
Tail lamp/stop lamp bulb
-
Remove the rear lamp assembly.
Refer to: Rear Lamp Assembly (417-01 Exterior Lighting, Removal and Installation).
-
Remove the screws and the and the bulb holder.
-
Remove the tail lamp/stop lamp bulb.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Liftgate reflector
NOTE:
LH rear lamp assembly shown...
Removal
NOTE:
RH side reversing lamp assembly shown, LH side similar.
Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation)...
Other information:
B1417:11, B1417:12, B1417:13, B1417:96
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM monitors the RH front impact severity sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Faulted RH front impact severity sensor
If a fault is..
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Module
DTC
Description
Action
PCM
P008A:00
Low Pressure Fuel System Pressure - Too Low: No Sub Type Information
GO to Pinpoint Test HC
..