Ford Ecosport: Multifunction Electronic Modules / Description and Operation - Module Controlled Functions - Overview

Ford Ecosport 2014-2026 Service and Repair Manual / Electronic Feature Group / Multifunction Electronic Modules / Description and Operation - Module Controlled Functions - Overview

Body Control Module

The BCM controls:

Battery saver function
Brake shift interlock
Delayed accessory function
Dimmable backlighting
Exterior lighting
Ignition state messaging
Interior lighting
Key validation (part of PATS )
Tailgate release
PATS (without push button start)
Perimeter alarm
Power door locks (vehicles without door module)
Post crash alert function
RKE system (without push button start)
TPMS
Transport mode

Multifunction Electronic Modules

Description and Operation - Module Controlled Functions - Component Location

Item Description 1 BCM 2 PDM (if equipped) 3 DDM (if equipped) 4 RDM - LH (if equipped) 5 RDM - RH (if equipped) ..

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Heater Core Leak Check - Vehicles With: R1234YF Refrigerant

Inspection NOTE: A coolant leak in the heater hose could follow the heater core tube to the heater core and appear as a leak in the heater core. Inspect for evidence of coolant leakage at the heater hose to heater core attachments. NOTE: Spring-type clamps are installed as original equipment. Installation and overtightening of nonspecified clamps can ..

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Mass Air Flow (MAF) Sensor

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect and remove the MAF sensor. Torque: 18 lb.in (2 Nm) Installation To install, reverse the removal procedure. ..

Removal and Installation - Wheel Knuckle Bushing

Special Tool(s) / General Equipment

Hydraulic Press

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel knuckle.
Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
Torque:
Stage 1: 177 lb.in (20 Nm)
Stage 2: 76 lb.ft (103 Nm)