Ford Ecosport: Electronic Feature Group / Multifunction Electronic Modules
Removal
Side obstacle detection control module
NOTE:
This step is only necessary if a SODL or SODR is being replaced.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module...
Body Control Module
The BCM controls:
Battery saver function
Brake shift interlock
Delayed accessory function
Dimmable backlighting
Exterior lighting
Ignition state messaging
Interior lighting
Key validation (part of PATS )
Tailgate release
PATS (without push button start)
Perimeter alarm
Power doo..
Other information:
Removal
NOTICE:
Do not spill brake fluid on painted or plastic surfaces or
damage to the surface may occur. If brake fluid is spilled onto a
painted or plastic surface, immediately wash the surface with water.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the wheel and tire.
Refer to: Wheel and Tire (204-04A Wheels and Tires, ..
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Center Punch
Copper Hammer
Removal
NOTE:
The max articulation of any CV is 5 degrees. If the CV or any U-joint
of the driveshaft is articulated further then the max allowable degrees
damage may occur.
NOTE:
Removal steps in this procedure may contain installation details.
..