Ford Ecosport: Exterior Lighting / Removal and Installation - Reversing Lamp

Ford Ecosport 2014-2026 Service and Repair Manual / Lighting / Exterior Lighting / Removal and Installation - Reversing Lamp

Removal

NOTE: RH side reversing lamp assembly shown, LH side similar.

Remove the rear bumper cover.
Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).

1. Disconnect the electrical connector.
1. Release the tabs and remove the reversing lamp assembly.

Installation

To install, reverse the removal procedure.

Removal and Installation - Rear Lamp Bulb

Removal Turn signal bulb NOTE: RH rear lamp assembly shown, LH rear lamp assembly similar. Remove the rear lamp assembly...

Removal and Installation - Stoplamp Switch

Removal NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch and cruise control deactivation switch...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Low/Reverse Clutch Assembly

Low/Reverse Clutch For low/reverse clutch operation, REFER to: Transmission Description - System Operation and Component Description (307-01B Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Description and Operation). REFER to: Transmission Description (307-01B Automatic Transmission - 6-Speed Automatic Transmission – 6F35, Description and Operation)...

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Climate Control Housing

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the instrument panel upper section. Refer to: Instrument Panel Upper Section (501-12 Instrument Panel and Console, Removal and Installation)...

Removal and Installation - Oil Pressure Switch

Materials

Name Specification Motorcraft® Thread Sealant with PTFE
TA-24-B WSK-M2G350-A2

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
If equipped, remove the bolts and the underbody shield.