Ford Ecosport Owners and Service Manuals

Ford Ecosport: Instrumentation, Message Center and Warning Chimes / General Procedures - Reset the Oil Change Indicator

Activation

  1. Without starting the engine, place the ignition in RUN.
  1. Using the message center switch, navigate and select MAINTENANCE from the menu. REFER to the Owner Literature for additional information about the message center menu navigation.
  1. NOTE: The CONFIRM SERVICE option is only available in the menu if the message center displays the SERVICE REQUIRED popup.

    Select CONFIRM SERVICE to display HOLD OK TO CONFIRM SERVICE.
  1. Press and hold the OK button to confirm service until SERVICE DONE is displayed.
  1. Place the ignition in OFF.
  1. The oil life reset procedure is complete.

    Diagnosis and Testing - Instrumentation, Message Center and Warning Chimes

    DTC Chart: Instrument Panel Cluster (IPC) Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

    General Procedures - Seatbelt Minder Deactivating/Activating

    Activation   WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Battery and Cables - System Operation and Component Description


    System Operation Battery and Cables Vehicles are equipped with a 12-volt, maintenance-free battery. The battery is a 12V DC source connected in a negative ground system and is a voltage stabilizer for the 12V electrical system. A battery monitoring sensor is attached to the negative battery cable...

    Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Transmission Fluid Level Check


    Materials Name Specification Motorcraft® MERCON® LV Automatic Transmission FluidXT-10-QLVC WSS-M2C938-AMERCON® LV,   Check Connect the diagnostic scan tool to the vehicle. Monitor the TFT PID . With the engine running in PARK on a level surface make sure the transmission is at normal operating temperature 85-93° C (185-2..

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com