Ford Ecosport: Intake Air Distribution and Filtering - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Air Cleaner

Ford Ecosport 2014-2026 Service and Repair Manual / Engine / Intake Air Distribution and Filtering - 2.0L Duratec-HE (129kW/175PS) / Removal and Installation - Air Cleaner

Removal

NOTE: Removal steps in this procedure may contain installation details.

- Loosen the clamp and disconnect the MAF sensor electrical connector.
  Torque: 35 lb.in (4 Nm)
- Disconnect the air cleaner inlet tube.
- Remove the Isolator screw.
  Torque: 18 lb.in (2 Nm)
- Disconnect the resonator pipe and remove the air cleaner assembly.

NOTICE: Clean, inspect and cover all open ports.

Installation

To install, reverse the removal procedure.

Diagnosis and Testing - Intake Air Pressure and Temperature

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...

Removal and Installation - Air Cleaner Outlet Pipe

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect and position aside the vent tube...

Other information:

Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - Transmission Fluid Cooler

Removal NOTE: Removal steps in this procedure may contain installation details. Refer to: Radiator (303-03B Engine Cooling - 1.5L Duratec (90kW/120PS) – I3, Removal and Installation). Refer to: Radiator (303-03C Engine Cooling - 2...

Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Pinpoint Test - DTC: E, Vehicles With: Rear Seat Side Airbag

B0011:11, B0011:12, B0011:13, B0011:1A Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM continuously monitors the passenger airbag stage 2 circuits for the following faults: Resistance out of range Unexpected voltage Short to ground Faulted passenger airbag If a fault i..

Removal and Installation - Wheel Knuckle Bushing

Special Tool(s) / General Equipment

Hydraulic Press

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel knuckle.
Refer to: Wheel Knuckle - Vehicles With: Rear Drum Brakes (204-02B Rear Suspension - AWD, Removal and Installation).
Remove the rear toe adjustment retainers and remove the wheel knuckle mounting bracket.
Torque:
Stage 1: 177 lb.in (20 Nm)
Stage 2: 76 lb.ft (103 Nm)